Check out these tips on how to increase your home’s heating efficiency and help lower your utility bill.
Leave it to the coldest of the cold snaps to remind you what areas of your home need better insulation. It’s the first winter in our new home, and it seems like with every drop in degree, there’s a new place I can find to insulate. I am going to win this battle, the battle of me vs. energy efficiency. It’s not always a lack of wall insulation to blame for a drafty and cool abode. Much of the time, you can improve the situation for a small price and bask in warm comfort.
Here are some quick tips that you can implement in a pinch.
Doors offer many gaps for cold air to blast through. If you’re looking for a temporary solution during the cold front, invest in double draft stoppers that sit beneath the bottom of your door (they fit under windows too!). They cost less than $10 each and immediately protect heat from leaking out and cold air from seeping in. (Side note: I suspect that you can also make these at home using round foam pipe insulation, somefabric and your sewing machine, or you can make a draft dodger using fabric and kitty litter).
If you’re looking for a more permanent draft stop, install a door sweep to lessen the flow of air beneath a door.
Vinyl foam weather seal does wonders to create a tighter seal around the top and sides of exterior doors. It’s squishy with one adhesive side that makes for quick and easy installation along the door frame. When the door is pushed shut against it, it creates a tight seal and will help keep the cold out.
You might notice cold air coming through switches and outlets that sit on exterior walls. Foam outlet and switch inserts like these do exist for these situations; they’re little pads that sit right beneath the wall plate to insulate between the cold electrical box and the warm room.
Insulate the Basement and Attic
While it isn’t advised to insulate the ceiling between the basement and the first floor, you can help to prevent cold air from getting into the basement by filling the end joists with insulation. I used an R-19 product cut to 10-inch lengths, and fit it loosely in between each end joist so that the soft side of the insulation was lightly against the outer wall. You don’t want it compact, but allow the thickness of the insulation to protect against cold air that may be seeping inside.
Finally, come springtime, take the time to reglaze paned glass windows. You will be able to tell which ones need a new glazing if you tap-tap-tap on the glass and feel (or see) that the glass is loose. Learn how to reglaze windows over here.
By: Emily Fazio with DIY Network